IP CAMERA NOT CONNECTING TO WIFI 1080P
1080P IP Network Camera Outdoor WiFi CCTV Security Wireless IR Night Vision Cam.
IP CAMERA NOT CONNECTING TO WIFI FULL
Night mode: infrared night vision + full color LED light. Button seen above lower side centerģ.Plug in the IP camera and press and hold the switch. Supports 355 degree translation /90 degree tilt. Connect the NVR and IP Camera directly to your router, switch. This is how I fixed the problem with the camera.ġ.Go ahead and open the Memory card compartment that’s held in place by two screws where the speaker is.Ģ.Now look right beside the memory card you will see a switch that’s seen below almost to the center of the image. Note: These instructions only apply for WiFi NVRs and Cameras.
That was until I discovered something that I was able to use to fix the camera 100% and now its working again. If the router has wireless MAC filtering turned on and the camera is not on the list of approved devices the router will not allow that wireless connection. Click on the Security Tab, then custom Level. Go to Start button>Control Panel and Internet Options. I gave up on the IP camera and decided that it was defective or it was not working anymore. The steps to connect to the camera are the same exempt now you will need to add the IP address of the DVR/NVR/IP Camera to the compatibility view settings of the software in order to show correctly. Each time it gave a error when I try to reset and reconnect the App without avail. Thanks to the PEER-TO-PEER (P2P) technology, you can connect via the Internet in seconds, even if your Internet connection does not have static IP address. If your camera cant connect well but your network is good, please take out your SD card and try again, may the SD card is incompatible. but the one I physically connected has a new 192 IP but only works when connected and on wifi the router cant see it. I went as far as deleting the Camera from the App and placing the QR code before the lens which worked fine before but the Camera would not detect the and connect to the app again. One of the cameras that I didnt setup on the new router can be detected by the router at a 10. I use the button on the cable that extend from the camera, the one with the cable and cap on it and nothing happened. The problem though is that although the IP Camera and app worked fine after a year of use it lost sync with the app and no matter what I did to try and set the device up again it would not setup. If the computer cannot detect the camera after you remove the cable, it proves the camera doesn‘t connect wifi successfully.
0 kommentar(er)
